Introduction:
JIC Fitting is a range of hydraulic fittings which is made in accordance to the SAE J514 standards. The acronym JIC stands for Joint Industry Council. It is likewise known as the JIC 37 degrees flare fitting because it's a thirty seven degrees flare seating area. These fittings are utilized on oil hydraulic methods in many fields (fuel delivery, etc...), mobile hydraulic equipment, shipbuilding, fuel power program. A JIC fitting device has three parts that create a tubing assembly: installing, flare nut, alpilean ice hack reviews (ventsmagazine.com explains) and sleeve.

Material:
Materials used-to fabricate JIC fittings are carbon steel and stainless-steel SS316L.

Sizes:
JIC body and flare nut are available in outer diameter ("OD) sizes between 1/8" to 1 2". Sleeve has two distinct reading measurements, metric size (mm) & inch outside diameter ("OD). Sleeve size can be bought from 3mm to 50mm as well as 1/8" to 2". Fitting sizes are specified by the corresponding outside diameter of the tubing for the numerous kinds of tube ends.

Working Pressure:
The typical working strain of the fittings ranges from 1000 to 5000 psi for different sizes & connections. The minimum burst stress is 4 times the working pressure. The JIC fittings should be able to withstand two times the working strain for a period of one minute without leakage or failure.
Remember to take note that the pressure rating of a same fitting may vary when it is connected to various equipments.. For example, if a fitting with a minimal performing pressure is attached to a pipe, it is going to result in an overall even lower working pressure. In all cases, always take into account the lowest pressure as the optimum working pressure of the system.

Just how does a JIC fitting works: For tube connections, the assembly surgery starts out of the preparation of the hose. To begin with, the nut and sleeve are inserted onto the conclusion of a tube. With the use of a flaring tool, create the conclusion of the conduit to thirty seven degrees. Next, firm up the nut by making use of a spanner till the nut is firm and also the sleeve grips upon the tube. In case the fittings are bench put together, the gripping actions may be motivated by revolving the tube manually as the nut is drawn down. When the tubing could no longer be driven by hand, the sleeve has gripped upon the tube. If this occurs,, firm up the nut by turning it one full turn. This might vary somewhat with different tubing substances, but for basic practice, it's a very good rule to go by.

Configurations of JIC Fitting: Commonly used connection sorts be made up of: JIC/BSPP Male Connector, JIC/ NPT Male connector, JIC union, JIC/NPT Swivel Male Connector, JIC/BSPP Swivel Male Connector.

Brand of JIC Fittings:
HS Corporation is a Korean manufacturer specializing in JIC Fitting. Established in 1980, HS Corporation has over thirty years of specialised expertise in producing fittings.